How to wrap wiring
Moderators: a j r, TDockside, Miles, Moderators
How to wrap wiring
What is the best way to wrap the wiring from the dash to the motor? I was thinking about using heat shrink tubing but I believe wire loom is cheaper. Thanks for any ideas.
-
Phill Blank
- Posts: 412
- Joined: Thu Jan 05, 2006 4:20 pm
- Location: Hurley, Wisconsin
JALL,
I have used the spiral split wire loom material for all my wiring runs. It is easy to add additial wire as needed or to bring out a set of wires any place along the wire run for accessories. I use tape to hold wiring in place at ends and any that break out along the run. I also use the plastic wire loom clips with screws to anchor to the ribs or cross members under the decking.
Good Luck,
Phill
I have used the spiral split wire loom material for all my wiring runs. It is easy to add additial wire as needed or to bring out a set of wires any place along the wire run for accessories. I use tape to hold wiring in place at ends and any that break out along the run. I also use the plastic wire loom clips with screws to anchor to the ribs or cross members under the decking.
Good Luck,
Phill
