Finishing the outside
Posted: Fri Jul 27, 2012 4:30 am
Well it has been slow going but I am about done with the interior of the boat. I have refinished the seats, seat supports and dashboards and have 6 coats of varnish on the inside after about 90% of the ribs were replaced, replaced the transom and the stringers. 2 more coats of varnish to follow.
https://app.photorocket.com/galleries/e ... 5a2e9beb14
I am going to start the finishing process on the outside of the hull.
I am planning to use System 3 epoxy fairing putty to fill screw holes, divots and smooth things out before I install the spray rails.
I treated the inside with CPES. Should that be done on the outside as well or go straight to the fairing putty?
Thanks
Steve
https://app.photorocket.com/galleries/e ... 5a2e9beb14
I am going to start the finishing process on the outside of the hull.
I am planning to use System 3 epoxy fairing putty to fill screw holes, divots and smooth things out before I install the spray rails.
I treated the inside with CPES. Should that be done on the outside as well or go straight to the fairing putty?
Thanks
Steve