Stem Removal Advice 59 Peshtigo SeaCoaster 473
Posted: Sat May 28, 2011 5:49 am
So far, working from under the full bunk trailer, I dropped the keel rollers and have pulled the wooden keel, found no rot, scraped it, scraped the garboards joint and reinstalled with LifeCalk and 16 frearson head silicon bronze screws 12 x 2" and 1 silicon bronze carriage bolt 1/4"x 20 x 3", washer and nut. To make the bolt, get the 5" from Jamestown and cut off at 3" so there will be no hidden threads sawing on the keelson. The originals were brass, the screws were straight slotted and were filled in without bungs just compound like Marine Tex. All came out without a problem, but I believe new bronze will keep her right for the next caretaker. I will use Marine Tex to recover them. Topside, I've cleaned the limber holes out and once it is warm and dry here, plan to seal the inside with CPES before adding a garboard drain and varnishing the bilge. Thanks to JoeCB for drawings and details on his restoration and to all of you for inspiration to uncover that first screw. This is a good community for ideas and examples.
I will next remove, clean and reinstall the metal planing keel, and the rollers under that area again working from beneath the boat.
I am looking for experienced advice on removing the metal stem cover and the original outer stem, is it one or two piece? With the keel rollers all in place, the full length bunks and the two bow side lapstrake supports will it likely be adequately supported? What makes a good primer to seal the stem and keel once all is back in place? I will be getting the Kirby Lemonade yellow to match the original paint and have some for the aqua parallelogram mixed up locally. I have a floor to make, window gasketing to replace and some engine cleanup to do but she will be splashed this year. Regards, John B. Fowler
I will next remove, clean and reinstall the metal planing keel, and the rollers under that area again working from beneath the boat.
I am looking for experienced advice on removing the metal stem cover and the original outer stem, is it one or two piece? With the keel rollers all in place, the full length bunks and the two bow side lapstrake supports will it likely be adequately supported? What makes a good primer to seal the stem and keel once all is back in place? I will be getting the Kirby Lemonade yellow to match the original paint and have some for the aqua parallelogram mixed up locally. I have a floor to make, window gasketing to replace and some engine cleanup to do but she will be splashed this year. Regards, John B. Fowler