Page 1 of 1
Meranti Plywood
Posted: Fri Oct 26, 2007 6:02 pm
by john
Anyone of knowledge of meranti plywood. Looks very similar to philippine.
Might be available in solid and plywood. Is there a marine grade?
Posted: Mon Oct 29, 2007 11:19 am
by Phill Blank
Look at the following website:
http://www.marine-plywood.us/mahogany_meranti.htm
They have marine grdae available.
Have not worked withthe wood, but looking it up onthe web I see it is being used for door and window framing and has very good chacteristics for stability, etc.
Phill
Posted: Mon Oct 29, 2007 4:24 pm
by john
Thanks
That's looks like it. Hopefully I can find it closer than Sandusky, but at least I know it exists.
Posted: Mon Oct 29, 2007 5:09 pm
by john
Good discussion going on at Woodenboat.com, thread titled "meranti plywood."
Turns out to best match I've seen is ribbon stripe sapele marine plywood as Phil Blank pointed out. Some places call it 1/4 sawm ribbon stripe African mahogany. Local lumber yard carries interior but not marine. Appears it should be manufactured under BS1088 or BS6566 difference being one is solid core and the other not. Anyone used it?
Posted: Mon Oct 29, 2007 6:06 pm
by a j r
I used it on the '61 Peshtigo Sea Lancer I restored this past summer for the deck. Looks great.
Andreas
Posted: Mon Oct 29, 2007 6:35 pm
by john
AJr
Meranti or sepele ribbon stripe? Was it BS 1088 or Bs 6566?
Posted: Mon Oct 29, 2007 7:00 pm
by a j r
Meranti BS 1088.
I had been using Okume BS 1088, but the local supplier is not stocking it any longer. He said Meranti is better anyway.
Andreas
Posted: Mon Oct 29, 2007 7:16 pm
by john
Were you able to get the brown out and get it to red? Pictures?
Thanks
Posted: Tue Oct 30, 2007 7:08 am
by a j r
HUH?
Posted: Tue Oct 30, 2007 12:54 pm
by calvin
The deck looks very good.....which type of plywood id that?
Posted: Tue Oct 30, 2007 1:11 pm
by john
Very nice work.
Did you use varish only? Stain? Bleach before stain?
Found out today that BS1088 for both Okoume and Meranti has a 1.5 mm or greater thickness in the top ply. The ribbon stripe I've been looking at only has 1/2 mm thick top ply.
Thanks
Posted: Tue Oct 30, 2007 3:21 pm
by a j r
The picture is the deck of a 1961 Thompson Bros. (Peshtigo) Sea Lancer. The plywood is 3/8 inch Meranti. It is stained with Z-Spar "Standard Mahogany" stain, then sealed with one coat Old Salem Sealer and about 11 coats of marine spar varnish - Interlux Schooner No. 96. NO bleach.
The boat is for sale.
Andreas
Posted: Tue Oct 30, 2007 8:30 pm
by john
Thanks
Posted: Wed Oct 31, 2007 1:59 pm
by calvin
Great lookin decks..grain is even and color is fantastic...thanks for the post looks like the grady will be in for a treat!