Keel replacement

sayuncle · Post by **sayuncle** » Fri Mar 04, 2011 6:17 am

The keel on my cedar strip TVT is in need of replacement due to rot. Has anyone tackled this one before? I don't think steam bending a new one will be a problem, but I am not sure how to get the shape right. Should I try to cut some of the bevel before I bend it or do that after? The bevel does not run the full length of the keel and the angle is not consistent. I have replaced the first 5 ribs so far and need to replace the next 5 also. I have a new outer stem cut to size, beveled, and ready for steaming. Since I will be removing most of the cedar while replacing the keel, most of it will be replaced. The attached picture shows the keel as I started the rib repair. I will attach more updated photos of the current state of repair.

Brad

http://www.flickr.com/photos/53928052@N08/5049656248/

sayuncle · Post by **sayuncle** » Sun Mar 06, 2011 6:28 pm

Added more photos showing progress. I have the first 10 ribs replaced. My plan is to tackle the keel next. Not sure how to do that yet.