naulotex

joelsm65 · Post by **joelsm65** » Thu Jun 08, 2006 1:28 pm

just recieved my floor, which is naulotex. i was wondering, anyone that has used naulotex, how did you put it down? with the paste or screwed it down. i m interested what others have done. thanks for any response
joel

txcaptdan · Post by **txcaptdan** » Fri Jun 09, 2006 2:44 pm

I just finished laying about 15 yards of Redrum product, basicly same as Nautilux. I went to Home Depot and got an exterior latex glue for outdoor carpet, it has worked out well , I used a trowel with 1/8'' notches and spread it thin. I applyed material and used a roller to squeeze out air bubbles the folded over to backside and stapled down with stainless staples and an electric staple gun-worth the cost!
I applied over old floorboards and new epoxy sealed plywood, both worked well and seem to holding well. The latex glue did require laquer thinner to remove once it started to set up. I have not seen any bleed through. Good luck

a j r · Post by **a j r** » Fri Jun 09, 2006 7:19 pm

ditto to above however I used Natolex adhesive for the Nautolex vinyl.

Andreas